(apologies if this post gets duplicated - email probs)
I just discovered that if I disconnect the keying line
from the MP, transmit is asserted correctly throughout
the cw message! Plug in the keying line, and transmit
only flashes briefly at the beginning of the message.
Again, any thoughts on getting this working are
appreciated. Is this problem present in other radios
or just the (my?) MP?
Tnx/73,
Barry N1EU
> > -----Original Message-----
> > From: writelog-admin@contesting.com
> > [mailto:writelog-admin@contesting.com]On Behalf Of
>N1EU
> > Sent: Thursday, December 20, 2001 01:10 AM
> > To: writelog@contesting.com
> > Subject: [WriteLog] PTT CW on 1000MP?
> >
> >
> > I'd appreciate help getting PTT cw working with a
> > 1000MP. I ran across this February message from
>Jon
> > K1US about sending cw to two radios:
> >
> > "It turns out that, at least with Kenwoods, no
>relays
> > are needed if WL is configured for CWPTT via rig
> > control. Found that if I put both rigs into their
> > Manual CW configuration by turning off their
> > semi-break-in VOX switches, and select CW PTT on
>Comm
> > option under Ports, CWPTT, that in WL the correct
>rig
> > PTT for either window goes on and the keying line
>does
> > its stuff on that rig, then releases. What a neat
> > trick!"
> >
> > Up until now I've always used bk-in cw or command
>port
> > PTT ssb successfully. When I try command port PTT
>cw,
> > the MP "transmit" indicator flashes briefly and
>stays
> > off as I hear the cw message played by the rig's
> > sidetone. Under "CW PTT" I've checked "Command
>rig on
> > COM port". I would expect to see "transmit"
>asserted
> > by WL throughout the cw message, which is what
>happens
> > with ssb messages. Any suggestions greatly
> > appreciated.
> >
_________________________________________________________________
Join the world?s largest e-mail service with MSN Hotmail.
http://www.hotmail.com
|