> -----Original Message-----
> From: Eric Pearson [mailto:epearson@prodigy.net]
> Sent: Wednesday, December 19, 2001 00:44
> To: Writelog; GilBaronW0MN
> Subject: Re: [WriteLog] Problem with 10 Meter Module
>
>
> > I have seen no reply. Am I the only one that sees this problem. Add a DX
> QSO
> > to the 10 MTR SSB log. Do not put ANYTHING in the QTH filed.
> >
> > It accepts the QSO which is wrong and it also scores it which is worse.
> >
> > I tried over and over it is reproducible. Anyone else?
>
>
> Gil, I also hit the enter key early a few times during the contest
> but noticed right away when I tried to type the exchange that
> the entry window had been wiped clean and I needed to edit the last
> QSO to add the exchange. I didn't see it as a problem but if you
> prefer a warning you can go to "Contest/Exchange Format Setup" and
> change the QTH field to "Required" so it won't take a blank field.
>
> I recommend that you re-think X-ing those QSO's that are missing
The X was done after I sent the log. The one I sent did have his call. I
understand that point.
By the way , I see no way to remove the X, that certainly should be
available. I probably am missing something.
> the exchange. It's not the fault of the ZL6 that you didn't
> record his exchange and he won't be happy when he gets penalized
> because he's not in your log.
>
> One change to the defaults that I always make at the start of a
> mixed-mode contest is to go to Setup/Parameter and check "Mode"
> so the mode shows in the Log Window. This is also useful in
> single mode contests to explain those mysterious B's that sometimes
> appear next to the sequence number.
>
Well as I said, the module needs a lot of work. I did later realize I could
have made it required, NOT something the user should have to do.
By the way, I can't prove it but I am ALMOST CERTAIN that I DID put in a
number from that ZL.
> 73,
> Eric - K6EP
>
>
>
|