Good Morning Scot,
Had no luck with the albany.net site. I have examined my ini file and I do
have an Object section that I suspect is not configured correctly. To
clarify the problem once more. I use the default site DX cluster. That comes
up OK but I can not link it to the main program. I am not networking but
using one computer and one radio. When I start WL I get the error msg 'Can't
create Ole Automation Object'. Do you know where I might see an example of a
real life ini file? Any sites that might be useful? Any other ideas you have
are very welcome.
Thank you again Scot.
Howard...K2HK
Howard M. Klein, K2HK
ARRL Life Member
DXCC Honor Roll
362 Confirmed Countries
A1 Operators' Club
>From: "Scot Herrick" <scot@k9jy.com>
>Subject: RE: [WriteLog] packet Ole Automation Object
To: <writelog@contesting.com>
>Date: Fri, 14 Dec 2001 19:36:24 -0000
>
>Hi Howard,
>
>You didn't mention you are trying to use DX Telnet with WriteLog, which
>this
>error message implies. There needs to be a line in WriteLog.ini covering
>this and the location of DX Telnet needs to match. There are specific
>instructions on this site:
>http://www.albany.net/~bg/WriteLog/WLdxTelnet.htm
>. From what I have seen, there is an incorrect path, you're missing a '\'
>at
>the end of the path, or your missing the line in the WriteLog.ini file. Hum
>us a few more bars; is something easy in setting it up.
>
>CU...Scot, K9JY
>
>K9JY's WriteLog User Support Site at:
>http://www.k9jy.com
>mailto:scot@k9jy.com
>
_________________________________________________________________
Join the world?s largest e-mail service with MSN Hotmail.
http://www.hotmail.com
|