Eddie,
Sorry for the confusion. I am running writelog 10.27g, I have MMTTY version
1.61b(beta) installed on my system and it works fine. I re-downloaded again
last night the SM6SRW plug-in Version 1.3 (or v13 depending on where you
look). I'll give your suggestion a try and let you know.
Don, thanks for the good word, I'll let you know also how it turns out.
73,
Bill KE5OG
----- Original Message -----
From: Eddie Schneider <edlyn@california.com>
To: Bill Brooks, KE5OG <ke5og@brooksdata.net>
Sent: Sunday, September 23, 2001 12:50 PM
Subject: Re: [WriteLog] MMTTY/RTTYRite Problem
> Bill:
>
> I'm confused with the version number of MMTTY (1.3??)
>
> To make WL 10.27g work with MMTTY you need the SM6SRW plug-in,
> MMTTYPluginforWritelog_v12 and MMTTY V1.61b (beta)
>
> I suggest you go into C:\Ham\Programs and delete mmrtty.ocx and
> MmTtyTnc.dll. Then install MMTTY v1.6b using the self installer utility
> provided. MMTTY will load into C:\ProgramFiles.
> Then load the SM6SRW plug-in using it's installer utility.
>
> Naturally, WL should not be running when you do all of the above :)
>
> If you still get an exception message, go to RTTYRite > TU type and make
> sure MMTTY is checked. Then go to Port and make sure NONE is checked. You
> may have to reboot WL for the parameters to get set. Hope this helps.
> Cheers, Eddie W6/G0AZT.
>
>
>
>
|