Dinsterdog@aol.com wrote:
>
> Well, after setting up my LPT port in "Set Up" for CW keying, I got the
> computer to key the rig with my cable...I clicked on the LPT1 for CW and it
> worked perfect......I am using LPT1 to key the computer. However, after my
> intial test went well, I re-booted and tried it again...now for some reason,
> the program is allowing me to change the port set up to LPT1, but it is not
> retaining my changes...when I go back to the program, it does not send any
> CW...so when I go in setup to see whats up, the port is back to the default
> setting. I am hitting "ok" after setting it for my system but it's not being
> retained. Man, this seems so basic- what the heck I'm I doing wrong here?
> How do I get my changes to stick and is there a way to make my LPT1 port a
> default so I don't have to set it up each time as the keying port??
>
> 73 Paul N0AH
>
> 73 Paul N0AH
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
Did you do a 'save configuration' before exiting? You must save the
changes for them to stick.
|