Hello Marek et al,
I thought I would reply to the reflector in case others want to know. You can
use
a PK232 to send CW with little problems in WriteLog. However, although there
is a way to do it (I think), there is no easy way to receive CW using the PK232
in
the RTTYrite window. I don't recommend it.
It's best to use a sound card to receive CW in the RTTYrite window, or use the
built-in CW decoder in the main WriteLog window. I haven't tried the latest
version
of WriteLog, but I know earlier versions required faster PC's (400 mhz or
better?)
to use the CW decoder activated from the Setup menu on the main Writelog window.
Neither one of my computers are fast enough to use the CW decoder so I haven't
tried it but I've heard it works great.
I believe that using the CW decoder is best when transmitting CW via
a COM or Parallel port.
Transmitting CW via a COM or Parallel port is highly recommended. The problem
with using a PK232 is that occasionally it's receive buffer fills up and the
MULT
lamp starts blinking and it stops sending CW until you turn the unit off then
back on.
If you must use the PK232 to transmit - OK. To receive CW, you can then use
a soundcard and the RTTYrite window.
As far as sending CW with the soundcard, I don't know if it's possible. I've
not tried
it. Maybe others can comment on it.
GL, Don AA5AU
----- Original Message -----
From: "Marek Niedzielski" <niedzielski@psary.tpsa.pl>
To: "WRITELOG" <writelog@contesting.com>
Sent: Friday, February 23, 2001 3:39 AM
Subject: [WriteLog] WL and CW - how?
>
> Hi all.
>
> I would like to use WriteLog to receive and send CW in RTTYRITE window.
> I have PK232 connected to my PC, but CW mode is not available (CW option is
> gray), if
> PK232 is set in TU Type menu.
> If I select Sound Blaster as TU Type, I can decode CW signals. But is it
> possible to send my signal?
> Is it possible to set somethink like PC generated CW? COMM ports are not
> shared between main and RTTYRITE windows...
>
> There is an option to generate CW signals by PK232 in main WL window. But is
> it possible to decode CW in this window?
> CW decode window works only with Sound Blaster, doesn't it?
>
> So, using CW decode window and SB to decode CW and use one of some method to
> send CW in main window
> (PC generated, PK232 etc) is only one way to 2-way CW? Is it possible to
> send CW from PC in RTTYRITE window?
> Any sugestions?
>
> Best 73 and many DXs!
>
> Marek SP7DQR
>
>
> --
> WWW: http://www.writelog.com/
> Submissions: writelog@contesting.com
> Administrative requests: writelog-REQUEST@contesting.com
> Problems: owner-writelog@contesting.com
>
>
--
WWW: http://www.writelog.com/
Submissions: writelog@contesting.com
Administrative requests: writelog-REQUEST@contesting.com
Problems: owner-writelog@contesting.com
|