WriteLog
[Top] [All Lists]

[WriteLog] WL Rig Control with IC761

To: <writelog@contesting.com>
Subject: [WriteLog] WL Rig Control with IC761
From: Edgar Brown, N6OU" <n6ou@arrl.net (Edgar Brown, N6OU)
Date: Sat, 9 Dec 2000 23:11:10 -0800
Just installed the 10.22 upgrade today. Works fine with the IC-761. Tuning
is not updated as the dial turns but when it stops.
----- Original Message -----
From: "Carsten Steinhöfel" <carsten.steinhoefel@web.de>
To: "Mailingliste Writelog" <writelog@contesting.com>
Sent: Friday, December 08, 2000 12:40 PM
Subject: [WriteLog] WL Rig Control with IC761


>
> Hi there,
>
> is anybody controlling an Icom IC761 with Writelog (10.22)?
>
> The frequency is set correctly at startup but when tuning the
> frequency is not updated in Writelog. Setting the frequency and
> mode also works. It does not make any difference if I set
> polling on or off.
>
> I know my CIV interface is OK because it is working with CT and
> with CIV-Commander by AA6YQ. What I realised is that the rig
> does send a few 0xFC bytes before it starts to send the frequency
> status when I start tuning. It also sends two 0x00 bytes before
> the frequency status in answer to the first frequency interrogation.
>
> 73 and thanks for any help
>
> Carsten (DL1EFD)
>
>
> --
> WWW:                      http://www.writelog.com/
> Submissions:              writelog@contesting.com
> Administrative requests:  writelog-REQUEST@contesting.com
> Problems:                 owner-writelog@contesting.com
>
>


--
WWW:                      http://www.writelog.com/
Submissions:              writelog@contesting.com
Administrative requests:  writelog-REQUEST@contesting.com
Problems:                 owner-writelog@contesting.com


<Prev in Thread] Current Thread [Next in Thread>