John,
Ah yes, you're right. Thanks!
--Ted, W2ZK
> -----Original Message-----
> From: WA9ALS - John [mailto:jfleming@shelbynet.net]
> Sent: Tuesday, December 05, 2000 1:59 PM
> To: Ted Roycraft; writelog@contesting.com
> Subject: Re: [WriteLog] Problem with Bandmap in WL 10.22B (and earlier)
>
>
> > If you then "Set Center Frequency" of the first bandmap, it
> > does what you expect BUT if you "Set Center Frequency" of
> > the second bandmap, your setting will get applied only to the
> > first bandmap. The second bandmap is stranded with a center
> > frequency of 0 Hz. and you can't change it.
> >
>
> I observe a difference between setting the center freq via
> 1) Clicking on the File Menu first, then set center etc (works)
> 2) Right-clicking on the bandmap to get the menu. If you do it this way,
> the center freq doesn't stick, but it will if you do it via method #1.
>
> There's something different between right-clicking and getting
> the same menu
> via the FIle Menu selection!
>
> The first bandmap is different sometimes because it is linked to a rig.
> Even if the rig is not attached, if you manually tell it that the
> rig is on
> 14200, and then try to center the bandmap on 21200, it won't stick.
> However, the "New Views" will work OK if you set the freq via the
> File Menu
> as described above. GL - 73
> ---------------------------------
> WA9ALS - John
> jfleming@shelbynet.net
> http://www.qsl.net/wa9als
> ---------------------------------
>
>
--
WWW: http://www.writelog.com/
Submissions: writelog@contesting.com
Administrative requests: writelog-REQUEST@contesting.com
Problems: owner-writelog@contesting.com
|