I was noticing this in SS CW on my IC-765. My FT-1000 always communicated
perfectly.
Rather than shut down the program, I found that if I just opened the port
set up window and then clicked OK, it seemed to get communication to the
radio going again.
Randy, K5ZD
> -----Original Message-----
> From: owner-writelog@contesting.com
> [mailto:owner-writelog@contesting.com]On Behalf Of Wells, Rick
> Sent: Sunday, November 19, 2000 3:59 PM
> To: writelog@contesting.com
> Subject: [WriteLog] Band Map Stops Updating
>
>
>
> In two hours of operating SS the band map has stopped
> updating/tracking the
> TS-850 frequency three times. It will however, continue to add callsigns
> worked, but on the same/last frequency.
>
> After closing the band map window, it will not reopen from Window-Band Map
> Window. Saving, exiting WL and restarting, everything is back to normal,
> for a while anyway.
>
> Ideas or experiences appreciated. I'm running WL 10.20B under
> Windows 2000
> Professional.
>
> 73,
> W2RW
>
> --
> WWW: http://www.writelog.com/
> Submissions: writelog@contesting.com
> Administrative requests: writelog-REQUEST@contesting.com
> Problems: owner-writelog@contesting.com
>
--
WWW: http://www.writelog.com/
Submissions: writelog@contesting.com
Administrative requests: writelog-REQUEST@contesting.com
Problems: owner-writelog@contesting.com
|