I just finished using version 10.19a in the CQWW contest. All went
well, and I was pleased.
What I did notice is that some of the (few) QSO's that I made using
split frequencies were incorrectly logged.
In WL's on-screen log, some had the receive frequency, some had the tx
frequency.
In the cabrillo format log, the same was true, except that one of the
ones that on-screen had the rx frequency now had the tx frequency. One
QSO stayed the same and never recorded the tx frequency at all.
My question is...how is this recorded? Do I have to put the other
station in the QSO field before entering the split? All I can think is
that I didn't always do this (no, not everyone ID's each QSO :-)
Any thoughts are appreciated, as I don't remember what the tx freqs
were in the incorrect cases.
Thanks in advance,
Eric W3DQ
Washington, DC
--
WWW: http://www.writelog.com/
Submissions: writelog@contesting.com
Administrative requests: writelog-REQUEST@contesting.com
Problems: owner-writelog@contesting.com
|