Where is a need for PTT line when you using a CW-Interface?
Modern radios using full qsk, ore if not use the radio vox for
TR/RX, this works fine.
73 Wil
"Roger Marrotte @ Mediaone" schrieb:
> Does anyone have a cable made up that combines the three functions of rig
> control, CW sending and PTT for a Kenwood TS-870S? If so can I get a
> description/diagram of the cable/circuit. I have a cable now for rig control
> and a separate cable for sending CW. Each is on a separate COM port and
> works fine. I understand that all three functions can be incorporated into
> one cable tied to one COM port. It sounds good to me. I was reading in the
> TS-870 manual, page 83, about the use of the RTS and CTS lines for rig
> control by the TS-870. I was also reading in the Writelog manual about the
> use of the DTR and RTS lines for sending CW, making up a Y cable, using
> jumpers, etc. I'm confused. Any help would sure be appreciated.
>
> Thanks, Roger, W1EM
>
> --
> WWW: http://www.writelog.com/
> Submissions: writelog@contesting.com
> Administrative requests: writelog-REQUEST@contesting.com
> Problems: owner-writelog@contesting.com
--
WWW: http://www.writelog.com/
Submissions: writelog@contesting.com
Administrative requests: writelog-REQUEST@contesting.com
Problems: owner-writelog@contesting.com
|