> Press ALT-T and then choose the number of seconds that you want in between
> sending and then select the Function key F2 . You might have to return to
> the ALT-T box to change the seconds interval, depending on how long your CQ
> message is. See how long it takes to send your CQ message and then add a
> few seconds. Hope this helps
The seconds is the delay between previous CQ end and next CQ begin... which
reminds me of a question I meant to ask the group at large.
Using 10.15 during WPX CW , I noticed that the granularity or resolution of
the CQ timer appears to be 1 second. If I am wrong please explain how to enter
fractions of a second, and if it is as stated, I would add .1 second increments
to the wish list.
Discovered when 2 seconds was too quick, and 3 seconds seemed like an
eternity <grin>. 2.5 and 2r5 were not allowed, and truncated to 2 seconds.
Dave K2XR
--
WWW: http://www.writelog.com/
Submissions: writelog@contesting.com
Administrative requests: writelog-REQUEST@contesting.com
Problems: owner-writelog@contesting.com
|