Hi Gerard,
First, I think something is amiss. When using the CW message buffers, the
PTT DOES stay keyed. I suspect that the LPT is not really keying the rig,
but it is already the "VOX".
If you can, take a look at the output of the LPT with a meter or scope to
see if it is actually doing anything, if not, you may need to look at setup
parameters to see what is missing. In particular check Setup/Ports and make
sure LPT is checked for CW and DVK and it is set for PC generates CW.
I just tried mine from 7 to 36 WPM and no drop outs with PTT from LPT.
Hope this helps
73, Ric KV1W
----- Original Message -----
From: Gerard Jendraszkiewicz <jend@midway.uchicago.edu>
To: <Writelog@contesting.com>
Sent: Tuesday, May 30, 2000 13:30
Subject: [WriteLog] PTT keying
>
> Hello All,
>
> Is there an easy way to keep the PTT active while playing a memory in CW
> ? The following happens....
> Rig is keyed with the LPT port.
>
> Memory contents: CQ CQ TEST KE9I
>
> What I get CQ (TR relay drops out) CQ (TR relay drops out) TEST (same)
> KE9I
>
> I can run in the VOX mode but thats a poor solution when using different
> speeds. At 28 WPM its ok, but at 18 WPM the VOX delay is too long.
>
> Ideas ?
>
> Thanks, Jerry, KE9I
>
>
>
>
>
> --
> WWW: http://www.contesting.com/writelog
> Submissions: writelog@contesting.com
> Administrative requests: writelog-REQUEST@contesting.com
> Problems: owner-writelog@contesting.com
>
>
--
WWW: http://www.contesting.com/writelog
Submissions: writelog@contesting.com
Administrative requests: writelog-REQUEST@contesting.com
Problems: owner-writelog@contesting.com
|