Ron: I'm stumped. Maybe you can help.
In the past I ran writelog with a KAM for both rtty and CW. Using DX4WIN
as the CW decoder. It takes a lot of room both in memory and on the
screen. So I decided with the new release try to incorporate the
writelog CW feature and maybe PSK. So I checked out my soundboard with
the checker and received a 7f, I guess thats good, bigger than 3f and the
results displayed said it had a possibility of working ???. So I
redirected my ts870 audio output from the Kam to the sound board line
input.. Following the instructions in your support rtty setup document
I set the TU type to SB afsk. Now I assume that I should see some kind
of signal on the rtty display. I do and it looks like white noise
through a filter with dancing red dots and lines. So I tuned in a cw
signal, no change. Then I changed the mode to cw, nothing. Now I tried
your wlogsoundmixer level control, no help. I increased the TS870 audio
out level to max. Nothing
Looking at the "Setting sound board Levels" document I tried to set them
up as shown, no help. However I noticed that none of the windows had a
title like "MASTER OUT" or "WAVE INPUT" Just "volume control" And I
can't set the Properties as shown to the mixer device "Windows sound
System mixer" It defaults to my sb mixer <underline>ESS audio drive
mixer</underline>.
I want to use writelog CW for WPX . Any suggestions?
Fritz Schewe "AD6G"
PO Box 1009
Gualala, CA 95445
--
WWW: http://www.contesting.com/writelog
Submissions: writelog@contesting.com
Administrative requests: writelog-REQUEST@contesting.com
Problems: owner-writelog@contesting.com
|