| To: | <vhfcontesting@contesting.com> |
|---|---|
| Subject: | [VHFcontesting] Larcan Amp Mod Question |
| From: | <k3sk@buckwalter.co> |
| Date: | Tue, 6 Sep 2022 11:16:48 -0400 |
| List-post: | <mailto:vhfcontesting@contesting.com> |
I'm in the process of completing the changes needed for my 220MHz amp. I'm using the Larcan 1KW version and on the original DC power plug there is a wire on one of the small pins that goes to Pin 8, "Step Start" on the RF Module VSWR Control Board. W8ZN's conversion package says to cut that wire when replacing the connector. Does it get reconnected anywhere or is it not needed? de K3SK Dave Buckwalter FM07 - Farmville VA _______________________________________________ VHFcontesting mailing list VHFcontesting@contesting.com http://lists.contesting.com/mailman/listinfo/vhfcontesting |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [VHFcontesting] Maybe 220 night this week., k3sk |
|---|---|
| Next by Date: | Re: [VHFcontesting] Larcan Amp Mod Question, mike repinski via VHFcontesting |
| Previous by Thread: | [VHFcontesting] Maybe 220 night this week., k3sk |
| Next by Thread: | Re: [VHFcontesting] Larcan Amp Mod Question, mike repinski via VHFcontesting |
| Indexes: | [Date] [Thread] [Top] [All Lists] |