Hello all...I have seen several folks post that it was difficult to
switch from WSJT to SSB. I don't understand this at all. On my radios,
I have "presets" for all the common channels that we use. So we have
Channel1 to be 50.125MHz, 2 would be 50.133, 3 would be 50.260, 4 would
be 50.265, 5 would be 50.313. To change from WSJT to SSB, just push the
down arrow until the VFO says 50.125, step on the footswitch, and talk
into the mike. To go back to FT8, just push the up arrow until the VFO
says 50.313 and click Enable TX. Seems pretty simple to me.
There is no need to over think these things.....
73 Marshall K5QE
_______________________________________________
VHFcontesting mailing list
VHFcontesting@contesting.com
http://lists.contesting.com/mailman/listinfo/vhfcontesting
|