Jarred - This is a known issue with the Elecraft transporters. Bill has given
you some good tips to resolve it. You can find out more information about this
problem by searching the Elecraft e-mail reflector. Here are two posts:
< http://www.mail-archive.com/elecraft%40mailman.qth.net/msg70748.html >
< http://www.mail-archive.com/elecraft%40mailman.qth.net/msg71896.html >
There are more.
The solutions above include making sure that the N connector is well grounded
to the case by scrapping paint from it, bypassing the DC line, and putting a
28MHz low pass filter in the IF drive line. But Bill’s suggestion to make sure
all the mating panels are connected to each other is the best place to start.
Let us know how it works out. - Duffey
_______________________________________________
VHFcontesting mailing list
VHFcontesting@contesting.com
http://lists.contesting.com/mailman/listinfo/vhfcontesting
|