Hello group!
After much too long of an absence, I plan to hit the road again in June and
activate a few grids for the contest :-)
I'm trying to configure a "new" laptop for logging. I have RoverLog up and
running well. In the past I have pre-recorded several different CQ messages
(one for each different grid I plan to activate). I like to have everything
ready before the contest, and when I get to the grid I load the correct message
and let it rip :-) Anyway, this time I can't seem to find where RoverLog
stores the different audio files for the voice keyer. Does anyone else do it
this way? Where are the audio files for the voice keyer stored?
Question number two:
I have a Garmin eTrex handheld GPS I use to identify my grid square. It works
fine, but I'm planning to buy one of the mapping GPS's for the vehicle soon and
wonder if there are any that will display grid squares now? I remember
several years ago this topic came up on the list and the general consensus was
the mapping GPS's did not do maidenhead. Has that changed in the last few
years?
Looking forward to doing the Rover thing again. I haven't planned the route
yet, but will likely put on 4 to 6 grids in the Indiana / Kentucky area.
73
Dan
--
K9ZF
Amateur Radio Emergency Service, Clark County Indiana. EM78el
former K9ZF /R no budget Rover ***QRP-l #1269
Check out the Rover Resource Page at:
<http://www.qsl.net/n9rla>
List Administrator for: InHam+grid-loc+ham-books
Ask me how to join the Indiana Ham Mailing list!
_______________________________________________
VHFcontesting mailing list
VHFcontesting@contesting.com
http://lists.contesting.com/mailman/listinfo/vhfcontesting
|