VHFcontesting
[Top] [All Lists]

Re: [VHFcontesting] Use of APRS in the Rover

To: vhfcontesting@contesting.com
Subject: Re: [VHFcontesting] Use of APRS in the Rover
From: "David Erickson" <erickson+vhf@mentis.org>
Reply-to: erickson@mentis.org
Date: Thu, 27 Dec 2007 07:29:52 -0500 (EST)
List-post: <mailto:vhfcontesting@contesting.com>
Why not beacon APRS 300 baud packet on HF?  A quick google search will get
you some good frequencies and bands.  Plus Depending on band conditions
during the contest you'll be more likely to be heard by someone during
most of the rove.

73's
Dave W3DIO
http://www.w3dio.org/


> ----- Original Message ----
> From: Dan Evans <dan.evans@insightbb.com>
>
>
>
> So how bad do you think the APRS signal is going to be for the 2m SSB
> station? ---------------------------
>
>
> The frequency difference between 144.39 and 144.2 is only 190-kHz.  This
> is much too narrow for a filter of any sort.  There are two general
> strategies to employ for APRS use in a rover:
>
> On the SSB side, use a transverter for SSB operation -- one with a high
> dynamic range front.  I use the SSB Electronics transverter on 2-meters,
> and the band is quiet within 5-kHz of a KW station only 8km from my home
> (when they are active).
>
>
> On the APRS side, use low power (really! 300mW may be ok), poor antenna
> (really!) and separate the antenna from the SSB antenna by as great of a
> distance as possible.  Remember, all you need to do is be heard by a
> digipeater and you'll be repeated for others to hear.  You'll already be
> on a hilltop or knoll, so probably LOS to a digipeater.  Alternately,
> consider powering-on the APRS system only when the QSO rate is low, or
> while in-transit and not on SSB, etc.
>
> As with so many other things, there are many variations of these
> strategies that can be made to work, but this can give folks a few ideas
> to digest.
>
> Regards,
> Ev, W2EV
>
>
> PS: The advice for APRS is *opposite* that of HamIM, where high power and
> good antennas are the norm.  Why the difference?  HamIM takes place on
> 147.585 (over 3-MHz away!), and is simplex in nature.  A 70-watt 1/2
> second TX is barely noticed on the 2m SSB transceiver.
>
>
>
>
>
> _________________________________________________________________________
> ___________
> Looking for last minute shopping deals?
> Find them fast with Yahoo! Search.
> http://tools.search.yahoo.com/newsearch/category.php?category=shopping
> _______________________________________________
> VHFcontesting mailing list
> VHFcontesting@contesting.com
> http://lists.contesting.com/mailman/listinfo/vhfcontesting
>
>


_______________________________________________
VHFcontesting mailing list
VHFcontesting@contesting.com
http://lists.contesting.com/mailman/listinfo/vhfcontesting

<Prev in Thread] Current Thread [Next in Thread>