I used someone else's Icom, I think it was a 2100, for a field event on
battery, and at the end of the day it started doing this.
Traced it to low battery voltage. All was fine after charging and/or new
batt. I don't remember what the critical voltage was, but when it started,
we could turn it off for a little while and get a short xmit out of it, on a
few extra recovered battery mV's before it did that again.
73, Skip
----- Original Message -----
> On Sat, 2003-07-12 at 09:13, AG2A wrote:
> > >Has anyone had a problem with the Icom IC-2100h not releasing from
> > >transmit after letting go of the ptt button? I must power off and on or
> > >pull the mic out of the rig to go back into receive. This started
after a
> > >ride in the car (rig not used mobile) to the field day site, where I
was
> > >going to use it for simplex contacts. It was working fine before the
trip
> > >and I feel that some option was engaged with the bouncing during the
> > >ride... I tried a cpu reset but it was no help. Any ideas out there??
> > >
> > > Tom - ag2a
|