Hi John,
I ran into the same issue a few years back.
I drilled out the holes in the upper rotor housing to 3/8" inch and used
these:
https://www.uboltsdirect.com/product/3-8-u-bolts-round-38-x-3-14-inside-widt
h/
They were available in stainless steel when I bought them, but if you call
them, they may still offer them in stainless.
Good luck & 73.
Matt
KM5VI
-----Original Message-----
From: TowerTalk <towertalk-bounces@contesting.com> On Behalf Of john simmons
Sent: Thursday, November 27, 2025 7:52 AM
To: TowerTalk@contesting.com
Subject: [TowerTalk] T2X u-bolt
I'm searching for these and not finding any at the usual sources- McMaster,
MSCDirect, etc. The specs are: 5/16"-18 x 3-1/4" x 4"
stainless. Any suggestions???
-de John NI0K
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|