Dale,
I have done homemade brackets that worked similar to the photo. Two
brackets a foot or so apart. Each bracket made out of two pieces of 1-1/2"
angle iron, 6" on one, 12" on the other. Two bolts clamp the angle iron to
the post and the tubing is held by u-bolts to the 12" extension on each
set. Sorry no photo, it was a long time ago.
You have me thinking, HI HI. I have a 40' self supporting 6x6 tilt-over
mast. A 20' aluminum tube clamped on there would almost give me a 80m
quarter wave :-)
73, Ken WA8JXM
On Sat, Sep 13, 2025 at 6:54 PM <browndog2344@gmail.com> wrote:
> I am planning to set up a BigIR with elevated radials. I have installed a
> 4
> x 4 post in concrete and will use a Delrin rod for the EHU support. I am
> having a difficult time finding a good 4 x 4 post to pipe (Delrin) bracket.
> I would rather not just get long u-bolts and drill holes in the 4x4 post.
> The following link looks to be exactly what I am looking for but is in the
> UK.
>
>
>
>
> https://www.aerialsandtv.com/wp-content/uploads/2019/11/Low-profile-brackets
> -pair-of-installing-a-pole-on-a-post-655W-L10.jpg
> <https://www.aerialsandtv.com/wp-content/uploads/2019/11/Low-profile-brackets-pair-of-installing-a-pole-on-a-post-655W-L10.jpg>
>
>
>
> Does anyone know of something similar in the US or have a better mouse trap
> to attach a pole to a 4 x 4 post?
>
>
>
> 73
>
> Dale
>
> AF7WH
>
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|
