Towertalk
[Top] [All Lists]

Re: [TowerTalk] Separating Aluminum Boom Sections

To: charlie carroll <k1xx@k1xx.com>
Subject: Re: [TowerTalk] Separating Aluminum Boom Sections
From: Bill Eisinger <Bill@theeisingers.com>
Date: Mon, 24 Mar 2025 01:02:48 +0000
List-post: <mailto:towertalk@contesting.com>
That’s where I am at the moment…I have it  sitting on saw horses with one end 
tied to a tree via a bolt thru the boom…nada so far…


Sent from my iPhone

> On Mar 23, 2025, at 6:56 PM, charlie carroll <k1xx@k1xx.com> wrote:
> 
> Bill:
> I had an almost identical problem many years ago.  A sturdy tree, strap, and 
> come along did it for me.  No heat, no pounding, just plain old pull.
> 
> 73 charlie, k1xx
> 
>> On 3/23/2025 7:51 PM, Bill Eisinger wrote:
>> Hello- I'm trying to pull apart two sections of an antenna 3" aluminum 
>> boom...each section is 18' long so the total length is 36' which makes it a 
>> bit unwieldly obviously. The antenna was in the air for 25+ years and the 
>> boom pieces have managed to weld themselves together.
>> 
>> Anybody have any ideas how to separate them?...I've tried heat, banging on 
>> it, etc, etc...because of the size there's no easy way to clamp one end that 
>> I can figure out. I've seen tools for separating muffler pipes but nothing 
>> for 3".
>> 
>> Any suggestions appreciated.
>> 
>> 73's
>> Bill, AA7X
>> _______________________________________________
>> 
>> 
>> 
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk@contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
> _______________________________________________
> 
> 
> 
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
<Prev in Thread] Current Thread [Next in Thread>