I recently purchased an unused TailTwister rotator for $20(!). I have been
using T2X's rebuilt by Norm's (I think) where the original terminal strip
was replaced by a plug/socket. I am 'assuming' they are wired the same but I
don't have a pinout to confirm before I connect the old plug to the new
socket. Does someone have a pinout I can use to compare and double check
first? It is in a 'current' manual...I only have an old manual before the
plug...
Thanks,
Allen R. Brier N5XZ
1515 Windloch Lane
Richmond, TX 77406
713-705-4801
--
This email has been checked for viruses by AVG antivirus software.
www.avg.com
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|