I wind my own on a toroid doughnut per K9YC cookbook and place it in a plastic
NEMA box. Then fab an alunimum plate and fasten it to the existing element
mounting brackets, and attach the box to it such that the output terminals can
be connected to the feedpoint with very short conductors.
Tom
K0SN
> On Dec 29, 2022, at 7:55 AM, tony.kaz--- via TowerTalk
> <towertalk@contesting.com> wrote:
>
> I have been following the thread on the W2DU baluns. I have been using the
> original Force12 balun (W2DU style balun). The leads corroded so need to
> replace. I have built toroid type baluns using K9YC's information. My
> question, how are folks mounting toroid style baluns on the C3? Hanging it
> below the feedpoint?TnxN2TK, Tony
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|