Can a new big grip be applied to a Phillystran guy in the same place where
one was removed?
I am rebuilding a set of PS guy cable assemblies. To accommodate new
hardware, I need to remove the big grips from twelve lengths of HPTG-6700I,
and put new big grips on with different hardware threaded through the loop.
PLP says that I should not reuse the big grips that were in place for
several years. But what about the three foot length of PS that used to be
under the BG?
When a BG is removed from PS, it leaves behind grit and plastic remains.
These can be removed with a rag and some mineral spirits, leaving the black
polyurethane jacket fairly clean. Is it OK to apply a new preformed BG to
the same three feet of PS?
As a side question, if I were to unwind just the long end of the big grip,
leaving the short end on the PS undisturbed, thread a new fitting on the
loop, and rewind the long end, would I have a useful termination that would
meet spec? I suspect that the answer is no, but what do others think?
Thanks in advance and 73,
Jim, W8WTS
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk