I believe the best way is to determine the resonant frequency of each element
using AutoEZ and then adjust the tips of you actual taper schedule/element to
match the original antennas. If I remember correctly AutoEZ will do that
automatically with the press if a key. While you are at it when you have
completed that task you might as well optimize the design also using AutoEZ.
Not required but perhaps slightly better if you have NEC-4.
Stan, K5GO
Sent from my iPhone
> On Jul 30, 2022, at 8:08 AM, Richard Thorne <rthorne@rthorne.net> wrote:
>
> Good find John,
>
> I've been studying K8CU's log periodic project. I'm toying around with the
> idea of experimenting/building a Log to go on my 78' tower. I've always
> wanted to try one. I have a pair of M2 10-30LP8's and I'll need to look at
> the tapers as K8CU uses different element sizes than M2 does.
>
> Rich - N5ZC
>
>> On 7/29/2022 9:31 PM, john@kk9a.com wrote:
>> Perhaps Element can be downloaded here:
>> http://www.realhamradio.com/Download.htm
>> John KK9A
>> Joe Subich, W4TV wrote:
>> Where is Leeson's workbook available?
>> 73,
>> ... Joe, W4TV
>> _______________________________________________
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk@contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|