I would use >1Mohm resistors from both terminals to the boom.
73
Peter, DJ7WW
-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces@contesting.com] On Behalf Of Jim
W7RY
Sent: Samstag, 11. Juni 2022 02:41
To: towertalk@contesting.com; towertalk@groups.io
Subject: [TowerTalk] Resistor Across a Choke Balun
I'm putting a Balun Design 1115t on an A4s. Here is the Ozarks, we have
*lightning!*
But I want to put a resistor across the antenna side to drain off any
static that develops across the un-grounded element. The A4 is a
balanced feed with not beta or gamma match. Just 2 isolated halves of
the driven element.
47K Ohm?
100K Ohm?
10K Ohm?
Thanks, 73, Jim W7RY
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|