I recently needed a two conductor cable for 12vdc power to an obstruction
light. Wasn’t happy with the flimsy stuff I had and instead used RG-6. Pretty
cheap and rugged.
Stan, K5GO/ZF9CW
> On May 4, 2022, at 7:32 PM, john@kk9a.com wrote:
>
> I assume that the shield is just on reed switch wires. It's easy to purchase
> two conductor shielded cable or even use coax and the motors can be run with
> semi-inexpensive THHN. If you have a long run you can use larger gauge for
> the motors to minimize voltage drop. BTW if you use a Green Heron controller
> the shield may not be necessary.
>
> John KK9A
>
> n6ta wrote:
>
> M2 cable for the OR2800 is $1.97/foot regardless of the length. It is 2, 12
> gauge and 2, 18 gauge shielded in a PE jacket. Said to be custom made. Any
> known alternatives for such a cable? I suppose I could look for more
> conductors and not use them, but the feedback must be shielded.
>
> Tnx,
>
> AL N6TA
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|