Hi Brad,
Good question as there are many knockoffs out there for Times Microwave LMR
cables, due to the very high popularity of the LMR (Land Mobile Radio) line.
Almost all of these knockoffs are made in China. L Com CA-600 is mfrd'd by
Signal Intelligence International of Hong Kong.
My firm buys nothing from China for equal reasons: We know that China's QC,
particularly relative to machining and extrusion, are not reliable. Secondly,
it is our firm's policy not to support human rights violating countries.
The listed price on L Com is $ 1.00 higher / ft than our price.
We sell a lot of LMR to military and commercials, hence our low pricing also
offered to our fellow hams.
There is also an alternative cable, with cost savings, equivalent size,
attenuation, and overall
specifications.
If you would like to contact me directly, I can further assess your application
and advise you of data that will help you make a decision.
73, Steve, K1PEK, Snr. Cable Design Engr. and Founder, DAVIS RF Co.
PS: Some folks may indicate that some of Times Microwave LMR is made in
China . This is correct, however, companies of the size of Times have their
own staffed mfr. plants with the same strict QC standards as the cables also
made in Wallingford, CT. I have dealt with Times for over 35 years. We
specify product made in CT. Also, I knew the retired chairman of L-Com, up
until his untimely/early death last December.
Today's Topics:
1. L-Com LMR-600 (K8ZM)
----------------------------------------------------------------------
Message: 1
Date: Fri, 11 Mar 2022 09:16:08 -0500
From: "K8ZM" <k8zm@oh.rr.com>
To: <towertalk@contesting.com>
Subject: [TowerTalk] L-Com LMR-600
Message-ID: <000601d83552$8e0bfb90$aa23f2b0$@oh.rr.com>
Content-Type: text/plain; charset="us-ascii"
Anybody have any experience with the LMR-600 take off from L-Com. Their
CA-600 seems to have the same specs but I never have seen any history on
them or any comments on the cables performance or longevity.
Thanks for any info.
Trying to replace many HF/VHF cable runs on the tower (NOT rotor loops),
about 60 ft lengths each run. I can get a decent price on CA-600 but don't
want to be penny wise and pound foolish. Was thinking of using LMR-600
crimp style connectors as well, a first for me but figure it allows for
"maintenance" if needed down the road. If there is a better coax solution
similar to LMR-600 please chime in as well !!
73 de Brad, K8ZM (ex-N8GLS)
ARRL Life Member
Member: NODXA (Northern Ohio DX Association)
Member: LCARA (Lake County Amateur Radio Association)
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|