I have a 100 ft tower that is surrounded by 36 100 ft radials and 4 x 20 50
radials. Coax and rotor cable are buried. The area is planted with grass.
I would like to add more radials but a question is what to do if additional
cables are needed past the radial field, e.g., for additional towers.
Here are a few options.
1. Try to put a 4 inch PVC pipe below the radials. Lots of work.
2. Remove or cut radials, bury a PVC pipe and then solder the radials. Less
work but soldering back critical
3. Just put cables on top. After 1-2 years they will migrate underground.
Not sure if a riding mower, or a truck (to install a new tower) can do
damage. Or enough damage creating intermittents, e.g., with OM8000
amplifiers (if purchased).
4. Bury 2-3 cables under the radials and use Green Heron stuff for WiFi
switching, including remote rotor controllers.
5. Route additional cables around the radial field with better coax to
compensate for extra length.
6. ???
Ignacy NO9E
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|