Thanks to all who replied to my question about a source for 3" O.D. aluminum
tubing.
One of the list members is going to send me a 39" piece. The I.D. of his
material is just
a little too small, but I can use a cylinder hone to remove the .009" or 010"
of excess
material. It will take awhile to do with a cylinder hone, but it will work. I
have done
this before, when I was working with boom material for my Telrex 40M346 copy
that I
built a few years ago.
Thanks again!
73 de Brad, N9EN
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|