[TowerTalk] K4IDC swingarm side mount for #45/55

[Bill Cotter <n4lg@qx.net>]

Mike,

I have purchased four of these Rohn-45 side-mount 
270deg swing-arms from Robin Midget, K4IDC. They 
are great, sure beat a ring-rotor for 
reliability. The last two I purchased in August 
of 2020. I suggest an e-mail or call.
Robin Midgett <K4IDC@comcast.net>
615-336-7091

73 Bill N4LG



At 05:26 PM 8/19/2021, you wrote:
> Gary http://www.idctechnology.net/sw/sw.html I 
> know nothing about this other than what it says. 
> Good Luck Mike KK9V On Thu, Aug 19, 2021 at 5:07 
> PM Gary Johnson <gwj@wb9jps.com> wrote: > Does 
> anyone manufacture swingarm side mounts anymore? 
> Looking for one that > fits 45G to support a 10m 
> monobander. Trying to avoid (most of) the > 
> fabrication process? > > Gary NA6O > 
> gwj@wb9jps.com > 
> ________________________________________________  
> > > > > 
> _______________________________________________ > 
>  TowerTalk mailing list > 
> TowerTalk@contesting.com > 
> http://lists.contesting.com/mailman/listinfo/towertalk  
> > -- Mike Stokes KK9V 
> _______________________________________________ 
> _______________________________________________ 
> TowerTalk mailing list TowerTalk@contesting.com 
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk