You can measure the load with an ohmmeter. If it's open or measures too high,
check the four screws that center the bottom of the load resistor in the shield
for tightness.
Wes N7WS
On 7/27/2021 1:56 PM, JOHN OWENS wrote:
It is pretty clear that my Heathkit Dummy load is Dead. I need to measure my
FTDX-101MP output on 6M (<200w) just to verify it is working as it should,
before I start tearing into my 5el 6M beam installation. Help would be
appreciated. I live in Edmonds , N of downtown Edmonds.
John Owens - N7TK
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|