> How does one put a gauge inline with the guy, set the tension and then remove
> it and restore the same tension?
Here is one way, there are probably others.
1. The turnbuckle is opened up all the way. The free end of the guy wire is
passed through the eye of the turnbuckle but not connected.
2. The tension gauge is connected to the guy wire above the turnbuckle with a
length of similar cable and wire rope clips or other fastening device.
3. A come-along is connected to the lower, free end of the gauge and to the guy
anchor.
4. The come-along is operated until the gauge reads the desired tension.
5. The free end of the guy wire is now terminated on the turnbuckle, either
with a thimble and clips or a "big grip".
6. The turnbuckle is ... turned ... until the gauge reads zero.
7. The gauge and come-along are disconnected.
--
Art Greenberg
WA2LLN
art@artg.tv
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|