I was thinking of 1/4" or 5/16" Phillystran which weighs 0.018 or 0.033
pounds/ft.
John KK9A
From: Haring family [mailto:dcharing@gmail.com]
Sent: Wednesday, April 21, 2021 3:08 PM
To: john@kk9a.com
Cc: TowerTalk@contesting.com
Subject: Re: [TowerTalk] Long span lanyard for wire antenna
You'll always have sag... less sag, with more tension...
Here is a calculator, with both ends at the same elevation. Using 1/2"
Phillystran for a 350' span, you have something like 23' of sag with a 100#
tension in the cable. You want very little sag? Better be prepared to have
significant lateral stress, and make sure your anchors and guying system is
designed for it. I didn't look any further for a calculator which would allow
uneven end heights...
https://www.spaceagecontrol.com/calccabl.htm?F=100&a=350&q=0.15&g=32.18503937&Submit+Button=Calculate
regards,
Dave N3AC
On Wed, Apr 21, 2021 at 12:48 PM <john@kk9a.com> wrote:
I am not a mechanical engineer but I am guessing that if he uses
Phillystran and allows for perhaps 10' of sag there is not a lot of
tension on the cable. Rope may be worse if it gets wet and heavier.
John KK9A
>
> On 4/21/2021 9:04 AM, Steve K8LX wrote:
>> Rather than be tempted to use high enough tension where turnbuckles
>> are needed, let it sag a little, give up a few feet of height -
>> your tower guy systems will appreciate it.
>>
>> -Steve K8LX
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|