| To: | Marvin Shelton <marvs@att.net>, "[TowerTalk]" <towertalk@contesting.com> |
|---|---|
| Subject: | Re: [TowerTalk] Ham IV part identificaiton |
| From: | "Joe Subich, W4TV" <lists@subich.com> |
| Date: | Tue, 9 Feb 2021 11:41:26 -0500 |
| List-post: | <mailto:towertalk@contesting.com> |
The Ham IV Manual identifies those screws as: p/n 5105700 #12-24 x 3/4" 73, ... Joe, W4TV On 2021-02-09 11:19 AM, Marvin Shelton wrote: Does anyone know what size bolt is used to hold the upper bell housing to the lower housing in a Ham IV?Marv K7IU _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contesting.com/mailman/listinfo/towertalk |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [TowerTalk] Ham IV part identificaiton, Marvin Shelton |
|---|---|
| Next by Date: | Re: [TowerTalk] Ham IV part identificaiton, Dave - W3NP |
| Previous by Thread: | [TowerTalk] Ham IV part identificaiton, Marvin Shelton |
| Next by Thread: | Re: [TowerTalk] Ham IV part identificaiton, Gary |
| Indexes: | [Date] [Thread] [Top] [All Lists] |