On 11/30/2020 12:44 PM, Kirk Kleinschmidt via TowerTalk wrote:
I may have improperly used my power ratio to decibels calculator.:)
With exactly 10 W going into the cables, I measured
8 W out (RG-11); 7.2 W (RG-213); and 7 W (RG-6) at 30 MHz.
Upon reflection (pun intended), my 2.8 dB figure can't be correct...
We can't use a 50 ohm wattmeter to measure loss in 75 ohm cable, thanks
to the standing waves resulting from the mismatch. A study of how
transmission lines work is advised. See the ARRL Handbook and Antenna Book.
What DOES work is the method I outlined earlier with AC6LA's spreadsheet
and a properly calibrated Vector Analyzer.
73, Jim K9YC
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|