Hello Grant:
As far as locating underground coax cables, I have had great success using
the Elecraft XG-3. I built a "flipper" adapter that takes the output center
conductor of the XG-3 and flips it on the outside shield for the coax cable
(the XG3 shield flips to the coax center conductor). Turn the XG3 on and use
0 dBm output hooked to the flipper and then to the coax under test. I use 80
meters. Then by using a hand held RX (SSB or CW) it is simple at ground
level to hear exactly where the coax is located. Terminating the far end of
the coax with a 50 ohm load can improve signal strength, but is not normally
needed.
73
Tim K3LR
-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces@contesting.com] On Behalf Of Grant
Saviers
Sent: Wednesday, October 28, 2020 11:11 AM
To: 'towertalk@contesting.com'
Subject: [TowerTalk] DIY conduit locator?
Trying to find a design for a empty conduit tracer. We've dug at a
couple of places at the 501c3 where it was "supposed to go", NG. Seems
to me this is a simple widget for energizing a test wire in the conduit
or some sort of mouse - LF or magnetic placed on the end of a snake.
Some googling hasn't found a design so hoping a towertalkian has a
design or link to one that works. This 2" conduit was installed some
time ago at 24" depth but where it routes is now lost.
The commercial tracers are $3000. My budget is more like $20. The
usual AM radio and dongle SDR's are available.
Also interested for when I need it to exactly locate my coax conduits
before digging.
Grant KZ1W
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|