Another way to handle this would be to drill entirely new holes at right
angles to the existing holes in the leg or legs that need adjustment.
Plug the unused holes so water doesn't get in there.
You can tell that I wouldn't go through a major re-engineer on this
thing for such a small problem.
-Steve K8LX
On 07/04/20 13:42 PM, Steve Maki wrote:
I should have made it clear that the 1st section would be on the base
attached with the bolts in at least one leg, and the section held plumb.
Then a half inch bit can be used to drill out the holes on the other
leg(s). That way you end up with 1/2" round holes all the way through,
not egg shaped holes.
-Steve K8LX
On 07/04/20 13:36 PM, Steve Maki wrote:
Structurally that amount of lean wouldn't be a problem.
I would hog out the holes to 1/2" and use 1/2" hardware. It's only a
40' tower.
Spray some cold galvanizing in there - a couple applications - and
call it good.
-Steve K8LX
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|