Correct, the TX2 has a 3” square bolt pattern, and the Yaesu has 3.3”.
Drilling a hole right next to the existing ones is going be tough, since they
will overlap a bit. Make a template with graph paper and rotate it 45˚ and
drill 4 new holes.
Chris
KF7P
> On Jan 12, 2020, at 1:04 PM, Charlie@thegallos.com <charlie@thegallos.com>
> wrote:
>
> Not the same. I actually make an adaptor (and sell)
> The TX-2 is six 5/16 bolts, the Yaesu is 4 8mm bolts,
> IF your tower has slots every 90 dogs, and the slots are wide enough to to
> fit 8mm it will work, but...
>
> —
> Charlie
> 73 de KG2V
> Http://www.thegallos.com
>
>
>> On Jan 12, 2020, at 5:45 PM, tommy@k6ye.com wrote:
>>
>> Jamie,
>>
>> They are NOT the same. I have both and originally had the T2 in a Hy-Gain
>> HD-54HD tower and retrofitted the 2800. The 2800 will now be inserted into a
>> HDX-555 tower.
>>
>> Good luck. OTOH, you could use an adapter.
>>
>> Semper Fi,
>>
>> Tommy - K6YE
>> DX IS and CW RULES
>>
>>
>>
>>> On 2020-01-12 16:06, Jamie WW3S wrote:
>>> Are they the same, or should I plan on redrilling the mounting plate
>>> is swapping rotors?
>>> _______________________________________________
>>> _______________________________________________
>>> TowerTalk mailing list
>>> TowerTalk@contesting.com
>>> http://lists.contesting.com/mailman/listinfo/towertalk
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk@contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|