John,
If I remember your post…. The TT rotor functioned when you had it at the base
of the tower ? and you not doing a trick instillation
A: + voltage transformer
B: remoting the starting cap
And you now say you have installed it on /in the tower and also installed new
Heavy-duty rotor cables ( 2-14 = 6 -18 ) or (2-12 6 -14 )
And the rotator dose not TURN ?
Turns SLOW ?
DO you hear the Brake wedge engage and release ? ( a screw driver pressed
against the tower and your ear you WILL hear the clunk if it is )
Wayne ,
Sent from Mail<https://go.microsoft.com/fwlink/?LinkId=550986> for Windows 10
________________________________
From: TowerTalk <towertalk-bounces@contesting.com> on behalf of
w5jmw@towerfarm.net <w5jmw@towerfarm.net>
Sent: Thursday, October 10, 2019 8:41:07 PM
To: TowerTalk@contesting.com <TowerTalk@contesting.com>
Subject: [TowerTalk] I just thought it was fixed.....
Still having problems with my run of rotor cable controlling the rotor.I
have done everything..rotor checks good at ground level.It is now
vertical,changed cables,same thing I am lost now...ideas? 73 john
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|