It won't take a lot of tonnage. 12T probably enough for the width you
might need. 20T surely enough. Easy to buy @ Harbor Freight or from
some auto parts stores, and a very useful tool for other press work.
The challenge with the usual antenna 6061-T6 is using the proper radius
dies as T6 is fully hard and will crack if bent on a sharp radius die.
Other softer alloys are a lot less challenging and of course less strong.
Here is a quality supplier with many die set choices, you need to have a
press that fits the width of dies and arbor plates better than the ones
from HF.
https://www.swagoffroad.com/SWAG-Press-Brake-Kits_c_53.html
I have several of their products but use die sets I welded up from hot
roll angles for bending steel to 3/8 in my 20T press.
Grant KZ1W
On 8/10/2019 9:42 AM, Tom Hellem wrote:
Hello Collective Wisdom-
I am thinking about building an H-frame hydraulic press for the purpose of
bending up some brackets out of 1/8" aluminum plate for element to boom
clamps on hf yagis.
Does anyone have an idea of the force required for doing this so I can
determine how big of a hydraulic jack to buy and how beefy I need to build
the frame?
Thanks in advance for any input.
Tom
K0SN
<https://www.avast.com/sig-email?utm_medium=email&utm_source=link&utm_campaign=sig-email&utm_content=webmail&utm_term=icon>
Virus-free.
www.avast.com
<https://www.avast.com/sig-email?utm_medium=email&utm_source=link&utm_campaign=sig-email&utm_content=webmail&utm_term=link>
<#DAB4FAD8-2DD7-40BB-A1B8-4E2AA1F9FDF2>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|