Many years ago I needed to put down horse proof radials. I rented a cable
laying machine that cut a slot in the ground and buried the wire all in one
operation. It would go down well over a foot which should be enough.
The downsides to this technique were: The machine was rather expensive; it was
articulated in the middle and I found it very difficult to steer so my radials
were quite wavy; it needed strong wire; it was easier to start from a small
trench - but the machine had a trencher on it.
Good luck!
73 RogerVE3ZI
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|