Towertalk
[Top] [All Lists]

Re: [TowerTalk] correcting aluminum tube

To: "'Richard \(Rick\) Karlquist'" <richard@karlquist.com>, "'Ken K6MR'" <k6mr@outlook.com>, "'Kim'" <whensley11@comcast.net>, <towertalk@contesting.com>
Subject: Re: [TowerTalk] correcting aluminum tube
From: "Gary Schafer" <garyschafer@largeriver.net>
Date: Wed, 17 Jul 2019 22:36:21 -0500
List-post: <mailto:towertalk@contesting.com>
I have done this and used an impact driver to turn the expander. It gets
very hard to turn by hand. Be careful that you don't overdo it.

73
Gary  K4FMX

> -----Original Message-----
> From: TowerTalk [mailto:towertalk-bounces@contesting.com] On Behalf Of
> Richard (Rick) Karlquist
> Sent: Wednesday, July 17, 2019 5:11 PM
> To: Ken K6MR; Kim; towertalk@contesting.com
> Subject: Re: [TowerTalk] correcting aluminum tube
> 
> 
> 
> On 7/17/2019 12:12 PM, Ken K6MR wrote:
> > If it's a reasonable size (around 2"  or 3" or so) go to Harbor
> Freight and get an "exhaust pipe expander".  Put in the bad end,
> tighten, and it will make the end round again.
> >
> >
> >
> > Ken K6MR
> >
> 
> Has anyone verified that this actually works?
> I tried to use an HF exhaust expander on 0.050" wall
> Al irrigation pipe and the screw became very hard to
> turn yet nothing happened to the pipe.  Did I do
> something wrong?  Seems like it should have worked.
> 
> Rick N6RK
> _______________________________________________
> 
> 
> 
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>