You're kidding, right?
Wes N7WS
On 5/30/2019 2:13 PM, Chuck Dietz wrote:
But you will need to model it to get the new lengths.
Chuck W5PR
On Thu, May 30, 2019 at 1:50 PM Wes <wes_n7ws@triconet.org
<mailto:wes_n7ws@triconet.org>> wrote:
No experience with this antenna, but 1/4 OD should be a even better
(snugger)
fit in .058" wall than .049".
Wes N7WS
On 5/30/2019 11:00 AM, AE5B wrote:
> Rebuilding a M2 6M7JHV after losing the tower in a Texas windstorm. One
> section of the boom will need to be replaced. Some of the elements
survived in
> reasonable shape and can be reused but a few of the element halves will
need
> to be replaced. M2's elements are 3/8"OD X .049" wall tubes with a
1/4"OD X
> 10" solid rod inserted. The only thing I have found is 3/8"OD X .058
wall 6063
> tubes. Will the thicker wall 3/8 OD elements be sufficient with inner rod?
> Comments and hints welcome from anyone who has rebuilt a JHV.
>
> John
>
> AE5B
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com <mailto:TowerTalk@contesting.com>
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com <mailto:TowerTalk@contesting.com>
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|