Towertalk
[Top] [All Lists]

Re: [TowerTalk] Calculating Forces for Tilting tower

To: n8de@thepoint.net
Subject: Re: [TowerTalk] Calculating Forces for Tilting tower
From: Dave Tipton <dave@w5dmt.com>
Date: Wed, 29 May 2019 09:05:46 -0500
List-post: <mailto:towertalk@contesting.com>
If I understand what you are saying, roughly (40x4)+(4x50) = 360 lbs

That is actually less than I anticipated.

Your concern about the wall, is however a shared one.  Thinking an internal guy 
running along a roof truss might be in order.

Dave

Sent from my iPhone

> On May 29, 2019, at 8:55 AM, n8de@thepoint.net wrote:
> 
> The tower will have its mass concentrated at the 20' level, and the 50 lbs 
> 'at the top' will have its mass concentrated at the 40'+ level.
> if the 'hinge' is at ground level and your winch is at the 10' level, the 
> total force of those two loads will be:
> 2x the tower load PLUS
> 4x the 'top' load.
> that's quite a bit for the position of the winch .. AND .. if the winch is 
> connected to the garage, it just might pull the garage wall down.
> 73
> Don
> N8DE
> 
> Quoting Dave Tipton <dave@w5dmt.com>:
> 
>> I have a 40 foot Rohn 25, with a tilt base section.   It will be  sitting 
>> next to a detached framed (not block) garage with siding.
>> 
>> I can attach a winch to an extra guy bracket I have at the ten foot level.
>> 
>> There will be roughly 50 lbs at the top of the tower.  (Rotator, Hex  Beam, 
>> GP3)
>> 
>> How much is the maximum force required to raise this from a cable at  the 10 
>> foot level?
>> 
>> Thanks,
>> Dave, W5DMT
>> 
>> Sent from my iPhone
>> _______________________________________________
>> 
>> 
>> 
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk@contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>> 
> 
> 
> 
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>