Gary... You can TRY Norms Fabrication. They are really difficult to deal
with though. The woman on the phone is not a business person thats for sure!
I don't know how folks run a businesses the way they do! I guess they
end up failing?
Thanks
73
Jim W7RY
On 5/13/2019 9:43 AM, Gary Johnson wrote:
I need two plates to fit Rohn 65G: An internal rotator shelf, and a top plate
for a thrust bearing. K0XG offers a rotator shelf but is totally unresponsive
to email or phone messages; maybe I'll write him a letter. (How the heck does
someone run a business that way?) Rohn does not seem to offer either of these
accessories but I'll call them just in case. I can fabricate these myself, if I
can get 65G drawings, but will not have access to a tower section until the
last minute... not the situation I really want. Looking for sources and other
ideas!
[Why 65G? It's a commercial installation. Hams get a ride, if we can come up
with this hardware.]
-Gary NA6O
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|