thanks Dale
unfortunatelly, this ArraySolutions only have one tab to add screws, so the
surface will touch the copper in some point.
https://www.arraysolutions.com/as-303u
Take care mi amigo!
73,
Jorge
El mié., 3 abr. 2019 a las 14:58, DALE LONG (<dale.long@prodigy.net>)
escribió:
> Better to use stainless steel washers between dis-similar metals.
>
> 73,
>
> Dale- N3BNA
>
> Sent from Yahoo Mail on Android
> <https://go.onelink.me/107872968?pid=InProduct&c=Global_Internal_YGrowth_AndroidEmailSig__AndroidUsers&af_wl=ym&af_sub1=Internal&af_sub2=Global_YGrowth&af_sub3=EmailSignature>
>
> On Wed, Apr 3, 2019 at 12:35 PM, Jorge Diez - CX6VM
> <cx6vm.jorge@gmail.com> wrote:
> Hello
>
> I will be doing coaxial grounding on shack entrance.
>
> Need to install ArraySolutions AS-303 surte arrestors on a copper surface.
>
> AS-303 have aliminium case. So, i will install them with two screws
> directly on the copper plate or is best to apply something to the two
> surfaces that will be in contact?
>
> thanks!
>
> --
> 73,
> Jorge
> CX6VM/CW5W
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>
--
73,
Jorge
CX6VM/CW5W
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|