I just had to buy some for a TH11 refurb. DX Engineering & Texas Towers
did not have 7/16. That is a odd size as most antenna makers use 1/2 &
3/8. HyGain uses 5/8 & 7/16 on some of their antennas. They have 7/16"
in stock and it was pretty reasonable, 68 " lengths were under $6. ea.
Much cheaper than the on line metal places.
Chuck
W6RD
On 3/17/2019 3:20 AM, Jim wrote:
DX Engineering.
Thanks
73
Jim W7RY
On 3/17/2019 5:14 AM, Brad Anbro wrote:
Hello all,
I am rebuilding an old HyGain 153BA 3-element 15 meter monoband yagi
and I
was wondering if there is a good source for the 7/16" diameter by
approximately
.039" wall thickness aluminum tubing that is used for the ends of the
element
half-sections?
Years ago, Texas Towers used to stock a wide variety of aluminum
tubing but
on their web site I see only two sizes listed.
Thanks for any help with this!
73 de Brad Anbro, N9EN
Bluff City, Tennessee
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|